Kubota V3600-E3 Shop Manual page 160

V3-E3B SERIES, V3-E3CB SERIES, V3-E3BG SERIES, WSM
Replacing Injection Pump Assembly
NOTE
• You can remove the injection pump assembly at any
crankshaft angle.
1. Remove the all injection pipes (1).
2. Disconnect the fuel hoses (6) and air bleeding hose (4) from the
injection pump unit.
3. Remove the solenoid (3).
4. Detach the sight cover (7) from injection pump unit.
IMPORTANT
• Do not deform the start spring (10).
5. Unhook the start spring (10) from the rack pin of injection pump
assembly.
6. Remove the anti-rotation nut (9).
7. Slide off the governor connecting rod (8) completely from the rack
pin of injection pump assembly.
8. Remove the injection pump assembly mounting nuts and screws.
NOTE
• If you can not remove the injection pump assembly easily,
arrange to change the angle of injection pump unit
temporarily.
9. Remove the injection pump assembly (5).
(1) Injection Pipe
(2) Connector
(3) Solenoid
(4) Air Bleeding Hose
(5) Injection Pump Assembly
(6) Fuel Pipe
(7) Sight Cover
S-68
DIESEL ENGINE
(8) Governor Connecting Rod
(9) Anti-Rotation Nut
(10) Start Spring
[A] Standard Mechanical Governor
[B] Electronic Governor
W1182379