Kubota V3600-E3 Shop Manual page 27

V3-E3B SERIES, V3-E3CB SERIES, V3-E3BG SERIES, WSM
Replacing Oil Filter Cartridge (All model)
CAUTION
• Be sure to stop the engine before changing filter cartridge.
1. Remove the oil filter cartridge (1) with the filter wrench.
2. Apply a slight coat of oil onto the new cartridge gasket.
3. To install the new cartridge, screw it in by hand. Over tightening
may cause deformation of rubber gasket.
4. After the new cartridge has been replaced, the engine oil
normally decrease a little. Thus see that the engine oil does not
leak through the seal and be sure to read the oil level on the
dipstick. Then, replenish the engine oil up to the specified level.
IMPORTANT
• To prevent serious damage to the engine, replacement
element must be highly efficient.
genuine filter or its equivalent.
(1) Engine Oil Filter Cartridge
Replacing Fuel Filter Cartridge (Cartridge Type)
Water and dust in fuel are collected in the filter cartridge. So,
change the filter cartridge every 500 hours service.
1. Remove the used filter cartridge with filter wrench.
2. Apply a thin film of fuel to the surface of new filter cartridge gasket
before screwing on.
3. Then tighten enough by hand.
4. Loosen the air vent plug to let the air out.
5. Start engine and check for fuel leakage.
(1) Fuel Filter Cartridge
G-15
G GENERAL
Use only a KUBOTA
W1015117
W1037062