Analog Devices VisualDSP++ 3.5 Manual page 75

Table 2-9. Blackfin Loader Command-Line Switches (Cont'd)
Switch
-Mt filename
-no2kernel
-o filename
-o2
-p #
-proc processor
-romsplitter
VisualDSP++ Loader Manual
for 16-Bit Processors
Blackfin Processor Loader/Splitter
Description
Specifies the make dependencies target output filename.
The option is for use with either the
-Mt
not present, the default is the name of the input file with the .
extension.
Produces the output file without the boot kernel but uses the
boot-strap code from the internal boot ROM. The boot stream gener-
ated by the loader is different from the one generated by the boot ker-
nel.
Note: Currently supported only for ADSP-BF535 processors.
Directs the loader to use the specified
loader's output file. If the
name of the input file with an .
Produces two output files: one for the Init block (if present) and boot
kernel and another for the user application code.
To have a different format from the application code output file, use
the
-kb -kf -kwidth
format, and the boot width for the output kernel file.
If you intent to use the
-02
• on ADSP-BF535 processors
-nokernel
• and/or
-l filename
ADSP-BF531/BF532/BF535/BF561 processors.
Specifies a hex PROM/Flash output start address for the application
code. A valid value is between [
must be greater than that specified by
tialization and application code are in the same output file (do not
use ).
-o2
Specifies the target processor.
The can be one of the following:
processor
,
ADSP-BF532 ADSP-BF533
Creates a non-bootable image only. This switch overwrites the
switch and any other switch bounded by the boot modes.
Note: In the file, declare memory segments to be 'splitted' as
.LDF
type " ". The splitter skips "
ROM
file if all segments are declared as "
The switch supports hex and ASCII formats.
-romsplitter
or -
-M MM
filename
is absent, the default name is the
filename
extension.
LDR
switches to specify the boot mode, the boot
switch, do not combine it with:
on
-init filename
,
0x0 0xFFFFFFFF
if both kernel and/or ini-
-kp
ADSP-BF531
, , and
ADSP-BF535 ADSP-BF561
" segments, resulting in an empty
RAM
".
RAM
option. If is
-Mt
LDR
as the name for the
]. A specified value
,
.
-b
2-45