Analog Devices VisualDSP++ 3.5 Manual page 104

ADSP-219x DSP Booting
-maskaddr 16
ANDed by
0xFFFF
EPROM.
The EPROM boot process assumes the boot device is connected to the
DSP's strobe. During runtime, typically the
/BMS
To use one EPROM for both booting and run-time issues, set the proper
control bits in the
/BMS
the individual
the and the
/BMS
Please refer to the Application Note EE-164 for further details and code
example.
3-18
switch (see on page
, and the resulting EPROM image fits into a 64-Kbyte
register. If several devices are connected to
E_STAT
strobes, an off-chip AND gate is recommended to OR
/MSx
strobes properly.
/MS0
3-22). Then all EPROM addresses are
/MSx
VisualDSP++ Loader Manual
strobes are used.
for 16-Bit Processors