Analog Devices VisualDSP++ 3.5 Manual page 142

ADSP-218x DSP Splitter Guide
Table 5-7. Splitter File Name Extensions
File Extension
.DXE
.BNU
.BNM
.BNL
Splitter Switches
Table 5-8 lists and describes the available splitter command-line switches.
Table 5-8. Splitter Command-Line Switches
Switch
sourcefile
outputfile
-byte
-dm
-i
-pm
-readall
5-18
File Description
Executable files and boot-kernel files.
Splitter binary output file—upper.
Splitter binary output file—middle.
Splitter binary output file—lower.
Description
Specifies the source (
.DXE
Specifies the splitter's output file.
If not specified, the name of the
for the output. The extension depends on the output format.
Produces byte-stream output format.
Extracts data memory.
Extracts segments from the executable declared as data memory. The
splitter generates two one-byte files:
—contains the upper bytes of the 16-bit data words
.BNM
—contains the lower bytes.
.BNL
Produces Intel hex output format.
Extracts program memory.
Extracts segments from the executable declared as program memory.
The splitter generates three one-byte files:
—contains the upper bytes of the 24-bit words
.BNU
—contains the middle bytes
.BNM
—contains the lowest bytes.
.BNL
Includes RAM and ROM in PROM.
Extracts both RAM and ROM segments from the input file. By
default, only ROM segments are extracted.
) for the splitter operation.
(executable file) is used
sourcefile
VisualDSP++ 3.5 Loader Manual
for 16-Bit Processors