Analog Devices VisualDSP++ 3.5 Manual page 108

ADSP-219x DSP Loader Guide
Table 3-6. Loader Command-Line Switches (Cont'd)
Switch
-Mo filename
-Mt targetname
-maskaddr #
-NoDxeAddrHdr
-o filename
-opmode #
-p address
-pEqualPd
-pEqualZero
3-22
Description
Writes make dependencies to the named specified.
The option is for use with either the
-Mo
present, the default is
<stdout>
Specifies the make dependencies target name.
The option is for use with either the
-Mt
present, the default is the name of the input file with the
Masks all EPROM address bits above or equal to
For example,
-maskaddr 18
(ANDed by ). The switch does not require
0x3FFFF
affects ROM section address only.
Does not generate the address header in the loader stream for the input
file.
.DXE
Specifies the name of the output file.
If no file name is specified, the output file takes the name of the input
file. The extension is
.LDR
For multi processing, when the
.DXE
inside the grouping, the file-relative byte address (that is, the value
-pd
in the address portion of the Intel hex information) is set to zero. The
value of zero is the default value but also can be set by
The value can be set to the value provided to the
by the switch). Further, it also can be set by specifying a
-PEqualPD
argument within the
-pd
.DXE Support" on page 3-7
information on pd groupings.
Specifies whether the boot kernel sets the DSP to 3-SPORT mode (
2-SPORT/1-SPI mode (
Specifies a hexadecimal integer as the PROM starting address.
For multi processing, if
.DXE
file must be created using
.LDR
name" and "-pd [address] inputfile"
Used inside the "-pd [address] inputfile"
for when specified in the
-p -o
to .
-pd
Used inside the "-pd [address] inputfile"
for when specified in the pd group is zero (default behavior).
-p -o
or -
-M MM
display.
or -
-M MM
masks all the bits above and including
.
-o filename.ldr
grouping. See "ADSP-219x DSP Multiple
and "-pd [address] inputfile"
) at the end of booting. Default is
1
specified in the
-p is
in the same pd group. See
-o
for details.
grouping. Sets the default value
group is the value of the argument
-pd
grouping. Sets the default value
VisualDSP++ Loader Manual
for 16-Bit Processors
option. If is not
-Mo
option. If is not
-Mt
extension.
.DOJ
.
#
A18
and
-romsplitter
is specified
.
-PEqualZero
switch (specified
-pd
-p
for more
) or
0
.
0
group, a new
-pd
"-o file-