Analog Devices VisualDSP++ 3.5 Manual page 110

ADSP-219x DSP Loader Guide
Table 3-6. Loader Command-Line Switches (Cont'd)
Switch
-waits #
-width #
3-24
Description
Determines the number of wait states for external accesses. Valid inputs
are to (inclusive). Default is
0 7
Note: For EPROM and Host boot modes only.
Specifies the bus width (in bits) for EPROM/Flash or Host booting.
Valid numbers are (default) and
8
register's
EMICTL E_BWS
For multi processing, if the width changes from one
.DXE
the next, a new file must be created by specifying
.LDR
group where has changed. See
-width
inputfile" for details.
.
7
. Width must correspond to the
16
bit.
"-o filename"
VisualDSP++ Loader Manual
for 16-Bit Processors
group to
-pd
in the pd
-o
and "-pd [address]