Analog Devices VisualDSP++ 3.5 Manual page 74

Blackfin Processor Loader Guide
Table 2-9. Blackfin Loader Command-Line Switches (Cont'd)
Switch
-kp #
-kWidth #
-l userkernel
-M
-maskaddr #
-MaxBlockSize #
-MM
-Mo filename
2-44
Description
Specifies a hex PROM/Flash output start address for kernel code. A
valid value is between [
0x0
not be used if no kernel or/and initialization code is included in the
loader file.
Specifies the width of the boot kernel output file when there are two
output files: one for boot kernel and one for user application code.
Valid values are:
• or for PROM or Flash boot kernel
8 16
• for SPI boot kernel
8
If this switch is absent from the command line, the default file width
is:
• the parameter when booting from PROM/Flash
-width
• when booting from SPI.
8
This switch should be used in conjunction with the
Specifies the user's boot kernel. The loader utilizes the user-specified
kernel and ignores the default boot kernel if there is one.
Note: Currently, only ADSP-BF535 processors have default kernels.
Generates make dependencies only, no output file will be generated.
Masks all EPROM address bits above or equal to
For example,
-maskaddr 29
including (ANDed by
A29
becomes
0x2000 0000 0x0000 0000
through , but based on your specific input file, the value can be
32
within a subset of
[0,32]
This switch requires
-romsplitter
address only.
Specifies the maximum block byte count, which must be a multiply
of 16.
Generates make dependencies while producing the output files.
Writes make dependencies to the named file.
The option is for use with either the
-Mo
not present, the default is
, ]. The specified value will
0xFFFFFFFF
#
(default) masks all the bits above and
). For example,
0x1FFF FFFF
. The valid
#
.
and affects the ROM section
or -
-M MM
display.
a <stdout>
VisualDSP++ Loader Manual
for 16-Bit Processors
switch.
-o2
.
s are integers
0
option. If is
-Mo