Assembling Your Keyset; Itp-5121D Setup - Samsung OfficeServ SMT-i5243 User Manual

ASSEMBLING YOUR KEYSET

• Place the keyset face down on a flat surface.
• Insert notched ends of the support bracket into the channels located in the
upper section of the bottom panel. Push towards the top of the keyset to lock
in.
• Plug the handset cord into the jack marked with the
• Route the handset cord out the RIGHT side of the keyset as you look at it face
down.
• Plug an eight-conductor ethernet cable, from the wall, into the jack marked
LAN on the back of the keyset. (Connect the ITP keyset to any port on the local
network).
• If your ITP will share LAN connection with a PC, plug an eight-conductor eth-
ernet cable, from the PC, into the jack marked PC on the back of the keyset.
• Plug the power connector, from the power adapter provided, into the power
jack on the back of the keyset. The power adapter is not required if the ITP is
connected to a LAN connection that provides power over the ethernet. The
ITP-5121D supports the power over ethernet feature when it is connected to
a IEEE 802.3af compliant LAN switch or power injector port.
IMPORTANT NOTE:
• Be careful not to connect the Network LAN cable into the PC connector of the
phone.
• To prevent damaging the keyset, only use the Power Adapter that came with
the 5121D keyset.
• This manual assumes that the ITP keysets are connected to a functioning local
IP network. The local IP network must be able to communicate with the main
processor and MGI channel in the OfficeServ 100, OfficeServ 500, or in the
OfficeServ 7000 Series systems over IP. This is assumed regardless of whether
the IP keyset is on a local or remote network.
8
symbol.

ITP-5121D SETUP

INITIALIZING THE ITP-5121D
Initially the ITP-5121D IP keyset will need to be setup to operate within the users
network.The Setup Menu is also used to make changes to the keyset, in the event
that the system information should change. The option chosen via scroll key will
be highlighted.
The station numbers will be automatically set by the OfficeServ 100, OfficeServ
500, and the OfficeServ 7000 Series systems once the necessary information has
been entered into the IP keyset. Enter ID and password of the server, as described
below to register the phone.
See your system administrator for specific Network and Server addresses. The
addresses necessary to set up the ITP-5121D are:
• IP Address of the ITP
• Network Gateway Address
• Subnet Mask
• IP Address of System's main processor
• User ID
• Password
To get to the Set-Up Menu, unplug the power from the ITP-5121D phone or
unplug the LAN cable if using Power over Ethernet, press and hold the MENU but-
ton while plugging in the power cord or LAN cable if using Power over Ethernet
back into the phone. Now release the MENU button.
>1.SYSTEM EASY WIZARD
2.SYSTEM INFORMATION
Other items not shown on screen when scrolling down (press down arrow on nav-
igation disc).
3.NETWORK SETUP
4.LOAD & UPGRADE SETUP
6.PHONE SETUP
7.FACTORY RESET
Home Page
5.SYSTEM SERVER SETUP
6.PHONE SETUP
7.FACTORY RESET
8.REBOOT
9