Navigating The Menus; Smt-I5220 Setup; Initializing The Smt-I5220; Setup Mode - Samsung OfficeServ SMT-i5243 User Manual

NAVIGATING THE MENUS

When programming within various menu options, information can be entered via
the dial pad keys using [0]-[9] and [Q Q ] dial keys. The button used for editing and
their features are summarized below.
BUTTONS
To move the cursor left and right, up and down.
Volume + and -
To clear/delete an entire field such as station name.
Hold
To write the changes and exit programming.
Transfer
To write the changes and exit programming.
Speaker
NAVIGATION BUTTON and SELECTOR
SWITCH FOR FWD/DND/ABSENT MSG
The SMT-i5220 phone has a navigation button and a Selector Switch for FWD/DND
to allow users to use its functions easily.
Selector Switch
Navigation Button
The Selector Switch can be used to manually set and cancel station Call
Forwarding and Do Not Disturb. NOTE: Do not use the access codes or the func-
tion menu to cancel FWD/DND/ABSENT MESSAGE when the selector switch is set
in the left or right position because the switch takes precedence over the access
codes/function menu.
BUTTON
Left
Center
Selector Switch
Right
Direction Key
Navigation
OK/Enter
12
FEATURES
Up Navigation Button
Right
Left
Navigation
Navigation
Button
Button
OK/Enter Button
Down Navigation Button
FUNCTION
Users can set the phone to the call forward
state.
The default standby status. (Normal Mode)
This is set to "Do Not Disturb" and absent
messge status.
Users can edit the contents on the screen or
move between menu items.
Users can select or save the item where a
cursor is placed in a menu mode.
Users can check the caller information
received from a station line during receiving.

SMT-i5220 SETUP

INITIALIZING THE SMT-i5220

Initially the SMT-i5220 IP keyset will need to be setup to operate within the users
network. The Setup Menu is also used to make changes to the keyset, in the event
that the system information should change. The option chosen will be highlight-
ed.
The station numbers will be automatically set by the OfficeServ 7000 Series sys-
tems once the necessary information has been entered into the IP keyset. Enter ID
and password of the server, as described below to register the phone.
See your system administrator for specific Network and Server addresses. The
addresses necessary to set up the SMT-i5220 are:
• IP Address of Station
• Network Gateway Address
• IP Address of System's main processor
• User ID
• Password

SETUP MODE

To get to the SETUP MODE unplug the power cord from the SMT-i5220. Press and
hold the , , button while you plug power back into the phone. Release the , , but-
ton when you see Samsung in the display. If you have a PoE (Power over Ethernet)
connection, the same procedure can be done by unplugging and plugging the
Ethernet cable into the phone while pressing and holding the , , button.
When the phone reboot is complete, the Language
Menu will display. Press the Yes soft button to advance to
the Configuration Menu.
Once the Configuration Menu is displayed, you can move to each menu in the
Setup by using the navigation button and [1]-[8] dial buttons of the SMT-i5220 IP
phone. To learn how to navigate the menus refer to the previous section.
Home Page
13