Table of Contents
Advertisement
EASY INSTALL WIZARD
By selecting this option, the System Easy Wizard can guide you through setting up
your network parameters. If you want to set up these parameters individually, fol-
low the instructions below.
•
From the idle phone press Menu, scroll to Phone, and press OK button. Scroll
to Phone Information and press OK button. From the keypad, enter the
administrator's password (please contact your phone system administrator).
Scroll to Easy Install and press OK button.
SELECTING THE STATIC IP OPTION
•
When the Static IP option is selected, enter the System Type OSSP (KP), and
press OK.
•
Enter the Static IP Address for the phone (eg. 192.168.9.193) then press the
OK button.
•
Enter the Subnet Mask (eg. 255.255.255.0); press OK button.
•
Enter Gateway Address (eg. 192.168.9.1), press OK button.
NOTE: Press the , key on the dial pad to enter the "." in the IP address.
•
Skip [VLAN-PHONE], [VLAN-PC], [802.1x Setting] by pressing the OK button
three times.
•
Enter the System IP address (eg. 192.168.9.200), press OK button.
•
Enter System ID XXXX (eg. 3201), then press OK button.
•
Enter Password XXXX (eg. 1234) then press OK button.
Wait a second for the phone to reboot. The phone should register and authenti-
cate itself to the phone system. Test SMT-i5220 for proper operation.
SETTING UP HOT DESKING
Hot Desking allows you to log in and out of your SMT-i5220 IP keyset without
rebooting.
•
Press the Menu soft button, scroll to Phone then press OK button.
•
Scroll to Phone Information and press OK button.
•
Enter the administrator's password (please contact your phone system admin-
istrator).
•
Scroll to Extension Login then press OK button.
•
Choose the ON option and press OK button. (Note: ON to allow, OFF to deny
hot desking).
•
Press the Save soft button to complete the setup.
•
When the phone restarts, enter the ID (eg; extension 2809) and password.
•
Press the Save soft button to complete the login.
14
[IDLE LOGIN]
CONFIGURATION MENU STRUCTURE
This menu is for administrator use and a password is required. The Configuration
Menu options are as follows:
1. EASY INSTALL
This option will guide you through setting up all required parameters for con-
necting the SMT keyset to your system.
2. PHONE INFORMATION
1.
Version Info: Provides boot rom, software, DSP, and hardware version
information.
2.
Network Info: Displays network mode, IP address of phone, network, and
gateway information.
3.
MAC Address
3. NETWORK
Displays Static IP, Dynamic IP, PPPoE, NAT, 802.1x, VLAN (LAN), and VLAN (PC).
4. SERVER
1.
Primary System: The main processor's IP address.
2.
System 1~3: Up to 4 server IPs can be set.
5. EXT. LOGIN
Allows the user to choose the option of permitting the phone either
login/logout from idle mode or only register to the server on power up. Once
the phone is placed into Extension Login mode, a display will show up to allow
you to enter any valid User ID and password. This function is also referred to
as hot desking (idle login).
6. S/W UPGRADE
1.
TFTP Server: The IP address of the TFTP server containing the IP software.
2.
Upgrade: Starts the IP software upgrade process.
7. FACTORY RESET
This option resets the SMT-i5220 to factory default settings.
8. PHONE RESTART
This option reboots the SMT-i5220 phone.
Home Page
15
Hide quick links:
Advertisement
Chapters
Table of Contents
