Samsung OfficeServ SMT-i5243 User Manual page 415

MENU STRUCTURE
The IP SETUP MENU is configured as follows:
1. SYSTEM EASY WIZARD
This option will guide you through setting up all required parameters for con-
necting the ITP keyset to your system.
2. SYSTEM INFORMATION
1. Version Info: Provides boot rom, software, DSP, and hardware version
information.
2. Network Info: Displays network mode, IP address of phone, network, and
gateway information.
3. Netmask
4. Gateway
Note that items 2 to 4 are only displayed when setting Manual IP.
3. NETWORK SETUP
This menu allows you to individually setup the same parameters found in the
Easy Wizard.
4. LOAD & UPGRADE SETUP
1. Upgrade TFTP Server:The IP address of the TFTP server containing the ITP
software.
2. Upgrade Start: Starts the ITP software upgrade process.
5. SYSTEM SERVER SETUP
1. Server IP Address: The main processor's IP address.
2. Server ID: The ID assigned to your ITP (see your phone administrator for
this information).
3. Server Pass: The password assigned to your ITP (see your phone adminis-
tratror for this information).
6. PHONE SETUP
1. Idle Mode: Allow or Deny access to the Hot Desking (Idle Login) feature.
7. FACTORY RESET
This option resets ITP to factory default settings.
8. REBOOT
This option reboots the ITP.
10
SETTING HOT DESKING (IDLE LOGIN)
Hot Desking allows you to log in and out of your ITP-5107S without rebooting.
• From the Main Menu, select
[6. PHONE SETUP] to turn Hot Desking
on or off.
• Select [1. IDLE MODE]
• Enter 1 to allow Hot Desking,
Enter 0 to deny Hot Desking.
• Press SPEAKER.
• Press HOLD.
SETTING THE NETWORK PARAMETERS
Utilize the following programming steps to program the ITP-5107S keyset to
operate within the users network. YOU CAN SELECT THE SYSTEM EASY WIZARD
TO PROGRAM ALL REQUIRED NETWORK PARAMETERS IF YOU WANT TO SET
UP THESE PARAMETERS INDIVIDUALLY FOLLOW THE INSTRUCTIONS BELOW.
Network Parameter Setup
Get into the SETUP MODE as shown on page
8. From the Setup, Main Menu, select [3.
NETWORK SETUP] to set or modify the net-
work parameters. Scroll to this option using
the volume [M]~[L] button and press SPEAKER.
Select the Network Mode Setup and press
SPEAKER, the LCD will display this message.
• If [1. MANUAL IP] is selected, the user must enter the IP address of the IP key-
set. Then enter the subnet mask, and gateway value for the customer net-
work.
• If [2. DHCP] is selected, the IP address, subnet mask, and gateway value will
be obtained automatically (if a DHCP server is present).
Home Page
6.PHONE SETUP
1.IDLE MODE
IDLE MODE En(1)/Dis(0)
0_
3.NETWORK MODE SET UP
>1.MANUAL IP
2.DHCP
11