Table of Contents
Advertisement
tion menu to cancel FWD/DND when the selector switch is set in the left or right
position because the switch takes precedence over the access codes/function
menu.
BUTTON
Left
Center
Selector Switch
Right
Direction Key
Navigation
OK/Enter
14
FUNCTION
Users can set the phone to the call forward
state.
The default standby status. (Normal Mode)
This is set to "Do Not Disturb" or "Absent
Message Status" .
Users can edit the contents on the screen or
move between menu items.
Users can select or save the item where a
cursor is placed in a menu mode.
Users can check the caller information
received from a station line during receiving.
SMT-i5243 SETUP
INITIALIZING THE SMT-i5243
Initially the SMT-i5243 IP keyset will need to be setup to operate within the users
network. The Setup Menu is also used to make changes to the keyset, in the event
that the system information should change. The option chosen will be highlight-
ed.
The station numbers will be automatically set by the OfficeServ 7000 Series sys-
tems once the necessary information has been entered into the IP keyset. Enter ID
and password of the server, as described below to register the phone.
See your system administrator for specific Network and Server addresses. The
addresses necessary to set up the SMT-i5243 are:
•
IP Address of Station
•
Network Gateway Address
•
IP Address of System's main processor
•
User ID
•
Password
SETUP MODE
[EXAMPLE OF SETTING MANUAL IP]
To set up the phone, power up the phone and wait for it to boot up. After booting
up, the display will show Easy Install Menu.
EASY INSTALL WIZARD
•
On [1. Start Easy Install] screen, make sure the net-
work cable is connected to the LAN port of the
phone and then press the Next soft button.
•
On [2. Setting Language] screen, select the lan-
guage and KeyPad Type and press the Next soft button.
•
On [3. Setting Register Server] screen, set the Server IP (the phone system's
IP address 192.xxx.x.200).
•
Enter the station ID (example 3205). Enter the password (example 1234).
•
Enter Server type OfficeServ (default); then press the Next Soft button.
Home Page
15
Hide quick links:
Advertisement
Chapters
Table of Contents
