Table of Contents
Advertisement
SMT-i5210 SETUP
INITIALIZING THE SMT-i5210
Initially the SMT-i5210 IP keyset will need to be setup to operate within the users
network. The Setup Menu is also used to make changes to the keyset, in the event
that the system information should change. The option chosen will be highlight-
ed.
The station numbers will be automatically set by the OfficeServ 7000 Series sys-
tems once the necessary information has been entered into the IP keyset. Enter ID
and password of the server, as described below to register the phone.
See your system administrator for specific Network and Server addresses. The
addresses necessary to set up the SMT-i5210 are:
•
IP Address of Station
•
Network Gateway Address
•
IP Address of System's main processor
•
User ID
•
Password
SETUP MODE
To get to the Setup Mode unplug the power cord from the SMT-i5210. Press and
hold the , , button while you plug power back into the phone. Release the , , but-
ton when you see Samsung in the display. If you have a PoE (Power over Ethernet)
connection, the same procedure can be done by unplugging and plugging the
Ethernet cable into the phone while pressing and holding the , , button.
When the phone reboot is complete, the Language
Menu will display. Press the Yes soft button to advance to
the Configuration Menu.
Once the Configuration Menu is displayed, you can move to each menu in the
Setup by using the navigation button and [1]-[8] dial buttons of the SMT-i5210 IP
phone.
To learn how to navigate the menus refer to the previous section.
14
EASY INSTALL WIZARD
By selecting this option, the System Easy Wizard can guide you through setting up
your network parameters. If you want to set up these parameters individually, fol-
low the instructions below.
•
From the idle phone press Menu, scroll to Phone, and press OK button. Scroll
to Phone Information and press OK button. From the keypad, press [,153#].
Scroll to Easy Install and press OK button.
SELECTING THE STATIC IP OPTION
•
When the Static IP option is selected, enter the System Type OSSP (KP), and
press OK.
•
Enter the Static IP Address for the phone (eg. 192.168.9.193) then press the
OK button.
•
Enter the Subnet Mask (eg. 255.255.255.0); press OK button.
•
Enter Gateway Address (eg. 192.168.9.1), press OK button.
NOTE: Press the , key on the dial pad to enter the "." in the IP address.
•
Skip [VLAN-PHONE], [VLAN-PC], [802.1x Setting] by pressing the OK button
three times.
•
Enter the System IP address (eg. 192.168.9.200), press OK button.
•
Enter System ID XXXX (eg. 3201), then press OK button.
•
Enter Password XXXX (eg. 1234) then press OK button.
Wait a second for the phone to reboot. The phone should register and authenti-
cate itself to the phone system. Test SMT-i5210 for proper operation.
SETTING UP HOT DESKING
Hot Desking allows you to log in and out of your SMT-i5210 IP keyset without
rebooting.
•
Press the Menu soft button, scroll to Phone then press OK button.
•
Scroll to Phone Information and press OK button.
•
Enter the administrator's password (please contact your phone system admin-
istrator).
•
Scroll to Extension Login then press OK button.
•
Choose the ON option and press OK button. (Note: On to allow, Off to deny
hot desking).
•
Press the Save soft button to complete the setup.
•
When the phone restarts, enter the ID (eg; extension 2809) and password.
•
Press the Save soft button to complete the login.
Home Page
[IDLE LOGIN]
15
Hide quick links:
Advertisement
Chapters
Table of Contents
