GE Security Concord 4 Installation Manual page 89

Note: To use this feature, the Open/close reports settings under the
specific CS phone or pager number.
To turn the setting off or on, do the following:
1. With the display showing CLOSING REPORTS OFF/ON (current setting), press 1 (off) or 2 (on).
2. The display flashes the entered setting. Press # and the display shows the new setting.
No activity option (06102 to 06601)
Default setting is Off.
When this setting is on, the panel sends a no activity report to the central station when the activity timeout
expires (see
TIMERS—ACTIVITY TIMEOUT
To turn the setting off or on, do the following:
1. With the display showing
flashes the entered setting.
2. Press # and the display shows the new setting.
Duress option (06103 to 06603)
Default setting is Off.
When this setting is on, the system can be controlled using a programmed duress code (see
to 6 settings on page 50) and will send a duress alarm to the monitoring station.
Note: For UL listed installations, Duress option must be set to off.
Do not use a duress code unless it is absolutely necessary. Using duress codes often results in false alarms due
to code entry errors. If a duress code is absolutely necessary, use it with the audio verification module to reduce
false alarms and accidental dispatches. The audio verification module is listen only.
To turn the setting off or on, do the following:
1. With the display showing DURESS OFF/ON (current setting), press 1 (off) or 2 (on).
2. The display flashes the entered setting. Press # and the display shows the new setting.
).
(current setting), press 1 (off) or 2 (on). The display
NO ACTIVITY OFF/ON
Phones menu on page 53 must be turned on for the
Chapter 3
Programming
Security partition 1
79