Downloader Programming - GE Security Concord 4 Installation Manual

Downloader programming

The panel can be programmed remotely using Enterprise Downloader. Use the information you recorded in
Appendix A, System planning sheets
this system.
A Downloader phone number should be programmed and the user-programmable option Downloading must be
powered on for remote downloader programming to work. Downloader programming has not been
investigated by UL.
To initiate an Enterprise Download session, do the following:
1. Contact your download station and ask the operator to prepare to download to the panel.
2. Make sure the system is disarmed.
3. Press 8 + system master code + 7 + 0 (any), 1 (down), or 2 (up). The display shows SYSTEM
DOWNLOAD IN PROGRESS during the downloading process.
If the alphanumeric touchpad does not display SYSTEM DOWNLOAD IN PROGRESS call the downloader
operator to verify the downloader phone number. Also, make sure Enterprise ToolBox is set up properly. Refer
to the Troubleshooting
to inform the downloading operator of the programming requirements for
on page 126 if the problem persists.
Chapter 3 115
Programming