Menu Navigation; Exiting Programming Mode - GE Security Concord 4 Installation Manual

42 Concord 4
Installation Manual

Menu navigation

There are two basic tiers of programming menus (Table 9).
Table 9. Tier 1 and 2 menus
System
#
program-
ming
B A
B
A
B
A
B
A
Arrows pointing right or down represent pressing B or # to advance forward through the menus. Arrows
pointing left or up represent pressing A or * to move through the menus in reverse. Only when
is displayed can you advance to tier 2 menus.
PROGRAMMING
Only when a specific menu is displayed can you advance to those menu settings. For example, from the
menu pressing
SENSORS
viewing/editing sensor programming. Settings in tier 2 menus can also be accessed by entering shortcut
numbers. See the section,

Exiting programming mode

After all installer/dealer programming is completed, to exit programming mode, do the following:
1. Press * until the display shows SYSTEM PROGRAMMING.
2. Press A or B until the display shows EXIT PROGRAMMING READY.
3. Press # and the touchpad displays the TIME AND DATE.
B
A
Security Phones
# #
Light Touchpad
B
controls A options
# #
Audio
B
Sensors verification
A
# #
Macro keys
gives you access to learning sensors, programming sensor text, deleting sensors, and
#
Tier 2 programming menus
B B
Phone
A
A
options
#
B B
A Reporting A
#
Accessory
B B
modules
A A
#
on page 45 for complete details.
B
A
Timers
#
Siren
B
options A
#
Onboard
B
options
A
#
SYSTEM