GE Security Concord 4 Installation Manual page 73

2. Hang up.
3. Call the premises again within the next 10 to 40 seconds. The system answers after the first ring.
When this feature is off, the system answers after 12 full rings.
To turn this feature off or on, do the following:
1. With the display showing RING/HANG/RING OFF/ON (current setting), press 1 (off) or 2 (on).
2. The display begins flashing the entered selection. Press # and the display shows the new setting.
Line fail delay (0213)
Default setting is None (partition 1 only).
This setting determines the amount of time the partition 1 phone line voltage must be absent before the panel
indicates a phone failure trouble condition. If a delay is not programmed (default), the panel will not monitor
the phone line voltage.
Note: Line fail delay is not available for partitions 2 to 6 at this time.
To set the Line fail delay time, do the following:
1. With partition 1 selected, press A or B until the display shows LINE FAIL DELAY nn SECS
(current setting).
2. Enter the time value (10 to 240 seconds).
3. The display flashes the entered setting. Press # and the display shows the new setting.
To delete the Line fail delay time, do the following:
1. With partition 1 selected, press A or B until the display shows LINE FAIL DELAY nn SECS
(current setting).
2. Press D to delete the current Line fail delay time.
Toll saver (0214 to 0264)
Default setting is On.
This setting determines whether the panel answers a phone call on the eighth ring (on) or twelfth ring (off)
when a trouble or alarm condition exists. To turn the setting off or on, do the following:
1. With the desired partition selected, press A or B until the display shows TOLL SAVER OFF/ON
(current setting). Press 1 (off) or 2 (on).
2. The display flashes the entered setting. Press # and the display shows the new setting.
Chapter 3 63
Programming