GE Security Concord 4 Installation Manual page 58

48 Concord 4
Installation Manual
Multipartition arm/disarm (0004)
Default setting is Off. Partition to turn On.
This feature controls which partitions can be armed/disarmed simultaneously when using a touchpad and
access code assigned to those partitions. When enabled, users can arm/disarm selected partitions using an
authorized access code. When disabled, multiple partitions cannot be armed/disarmed simultaneously. For this
feature:
• At least two partitions must be selected.
• Touchpads must be assigned to at least one of the selected partitions of this menu.
• Access codes must be assigned to all selected partitions of this menu. If the partition assignment for a
specific access code does not match the partitions selected in this menu, only those partitions common
to both menu settings can be armed/disarmed simultaneously with that code.
• A partition cannot be armed/disarmed if it is being controlled by another source at that time.
• All arming modifiers except Silent affect all partitions being armed. Only the arming partition can be
armed silently.
• When arming multiple partitions, any conditions that prevent arming are identified on touchpad
displays with the affected partition number flashing. The normal protest/auto force arm sequence
follows, or pressing * cancels the arming request.
• When disarming multiple partitions, any partitions in alarm have the affected partition number flashing
on touchpad displays. Pressing # cancels all alarms in the selected partitions. Alarm memory
information is then displayed for all canceled alarms.
To enable multipartition arm/disarm, do the following:
1. With the display showing MULTI-PIN ARM/DISARM_, press 1 to 6 to enter partitions (at least two).
2. The display flashes the partitions. Press # and the display stops flashing.
To disable mulitipartition arm/disarm, do the following:
1. With the display showing MULTI-PTN ARM/DISARM n n n n n n n, select all of the partitions
by entering the appropriate partition number.
2. The partition numbers disappear from the display. Press #.