Accessory Modules Menu; Accessory Modules - Bus Device Settings - GE Security Concord 4 Installation Manual

Accessory modules menu

The Accessory modules menu gives you access to the following menus:
Bus devices. This menu lets you read bus device unit numbers, assign bus devices to a partition, and
configure other features associated with a specific bus device.
SnapCards. This menu lets you set the configuration number for each SnapCard output, assign SnapCard
outputs to a partition, and name the SnapCard outputs.

Accessory modules - bus device settings

The following describes how to program the Accessory modules menu settings that appear under Bus devices.
Note: Most settings under Accessory modules - bus devices have no shortcut numbers.
Unit-ID (10000 to 10015)
Default setting is **** or None.
This menu lets you identify all connected bus devices, view each unit number, view the device ID number, and
configure other settings based on a specific device. This menu also lets you delete learned bus devices.
To help identify bus devices, the 8-digit device ID number is also located on a label on each SuperBus 2000
device.
To identify bus device unit and ID, do the following:
1. With the display showing BUS DEVICES, press #. The display shows the bus unit number and the
8-digit device ID number. For example: UNIT - ID 0—02110185. Where 0 is the unit number and
02110185 is the device ID number.
2. Press A or B to identify all other bus unit numbers (0 to 15) and device ID numbers.
To delete learned unit numbers, do the following:
1. With the display showing BUS DEVICES, press #. The display shows the bus device set to unit
number 0.
2. Press A or B until the bus device unit number you want to delete is displayed.
3. Press D. The display changes the unit number to None.
Device ID
Default setting is None.
This menu lets you change the bus device ID number when replacing a defective bus device. To change a
device ID, do the following:
1. With the display showing the desired bus device, press # + #. The display shows DEVICE ID (current
ID).
2. Enter the ID of the new bus device. The display flashes the entered selection. Press # and the display
shows the new setting.
3. Exit programming mode.
Chapter 3 93
Programming