Security Menu; Security - Global Settings - GE Security Concord 4 Installation Manual

46 Concord 4
Installation Manual

Security menu

The Security menu lets you choose whether security settings affect the whole system
settings) or a specific partition
security menu items, do the following:
1. With the display showing SECURITY, press #. The display should show GLOBAL.
2. Press # again to advance to global settings, or press A or B to display PARTITION n, then press # to
advance to selected partition 1 to 6 settings.

Security - global settings

This section describes how to program the Security settings that appear under Global.
Downloader code (0000)
Default setting is 12345.
Use the five-digit downloader code in conjunction with downloader programming. The downloader operator
must have the panel account number and downloader code in order to perform any programming.
Note: You cannot delete the downloader code from the panel memory. To change the downloader code to its default setting,
enter 12345 in the procedure to the right. The downloader code resets to defaults during a memory clear only if the
dealer code is not set or if the dealer code is used to initiate the memory clear. Downloader programming has not been
investigated by UL.
To program a downloader code, do the following:
1. With the display showing DOWNLOADER CODE nnnnn (current code), enter the five-digit code, and
press #. The display flashes the entered code.
2. Press # and the display shows the new code.
Installer code (0001)
Default setting is 4321.
The four-digit installer code is for entering program mode and changing system settings. If you program a
dealer code, only those settings not associated with phone numbers and the downloader code may be changed
Note: You may not delete the installer code or clear it from the panel memory. To change the installer code to its default
setting, enter 4321.
To program a installer code, do the following:
1. With the display showing INSTALLER CODE (current code), enter the four-digit code. The display
flashes the entered code.
2. Press # and the display shows the new code.
(Security partition 1 to 6 settings
(Security - global
on page 50). To access global or partition