Set Up Schedules Menu - GE Security Concord 4 Installation Manual

Voice chime (045)
Default setting is On.
This setting determines whether speakers connected to the phone interface/voice module or voice-only module
announce perimeter sensor/zone numbers that are tripped when the chime feature is on. This menu appears
only if a phone interface/voice module or a VOM is connected to the panel.
To turn voice chime off or on, do the following
1. Press A or B until the display shows OPTIONS.
2. Press # then A or B until the display shows VOICE CHIME OFF/ON (current setting).
3. Press 1 (off) or 2 (on). The display flashes the entered selection. Press # and the display shows the new
setting.
Chime on close (046)
Default setting is Off.
When this setting is on, the panel sounds a single chime when a perimeter door or window is closed.
To turn chime on close off or on, do the following:
1. Press A or B until the display shows OPTIONS.
2. Press # then A or B until the display shows CHIME ON CLOSE OFF/ON (current setting).
3. Press 1 (off) or 2 (on). The display flashes the entered selection. Press # and the display shows the new
setting.

Set up schedules menu

The Set up schedules menu lets you set up timeframes for light control, output control, automatic arming,
latchkey times, and exception opening/closing reports. The system (all partitions) allows you to set up to 16
schedules (00 to 15) which are shared by all partitions.
Setting up schedules consists of setting a start and stop time for each schedule, then selecting which days of the
week the schedule will be active. You can also set up a rollover schedule, which starts on one day and ends on
another day. This saves programming time and leaves more schedules available (in case they are needed later).
For example, to set up a schedule to rollover from Tuesday evening to Wednesday morning, set a schedule start
time for 2200 (10:00 p.m.) and a stop time for 0500 (5:00 a.m.). Set the schedule to turn on Tuesday. Because
the stop time is set for morning, the system automatically carries the schedule over to the next day.
If you use the same start and stop times described above and set the schedule to turn on Monday through
Friday, then one schedule will cover the entire week.
Set up schedules (05XXY, where XX is schedule 00 to 15 and Y is start [0]/stop[1] Monday to
Sunday [2 to 8])
Default setting is 00:00.
This menu lets you set up start/stop times for each day of the week. Schedules used by one partition cannot be
viewed or changed from a different partition.
Chapter 3 109
Programming