Audio Verification Menu; Audio Verification - Partition 1 Settings - GE Security Concord 4 Installation Manual

Audio verification menu

The Audio verification menu lets you set up the audio verification module (AVM) operation in partition 1. If
you want audio verification for partitions 2 to 6, you must install a standalone audio verification module and a
4-relay output module (HOM) (60-770) output for that partition.

Audio verification - partition 1 settings

The following describes the Audio verification menu settings that appear under Partition 1.
Audio verify (09000)
Default setting is Off.
This setting determines whether or not the system can be accessed by phone for alarm verification.
To turn the setting off or on, do the following:
1. With the display showing AUDIO VERIFICATION, press #. The display shows PARTITION 1.
2. Press # again and the display shows AUDIO VERIFY OFF/ON (current setting). Press 1 (off) or 2
(on).
3. The display flashes the entered setting. Press # and the display shows the new setting.
Audio mode (09001) audio verification-partition (default=1)
This setting determines how the audio verification module operates. Choose one of the following:
Instant (1). Allows the central station operator instant access for an audio session by entering the AVM
code or by pressing * (if an AVM access code is not programmed) upon completion of panel alarm report
(see Access timeout (09004)
except for fire alarms, even if the operator extends the session by pressing any valid key.
Callback (2). Allows the central station operator to place a call to the premises within five minutes of the
alarm report (panel picks up after one ring). The operator must press * or enter the AVM access code
within 20 seconds after ring. The panel does not report any alarms during the AVM session except for fire
alarms, even if the operator extends the session by pressing any valid key.
Callback silent (3). Same as Callback, except premises phones do not ring.
To set Audio mode, do the following:
1. With the display showing AUDIO VERIFY OFF/ON, press A or B until the display shows AUDIO
MODE nn (current setting).
2. Enter the desired mode number (1 to 3).
3. The display flashes the entered setting. Press # and the display shows the new setting.
on page 90). The panel does not report any alarms during the AVM session
Chapter 3 89
Programming