Table of Contents
Advertisement
Table 7. Service Processor Error Codes (continued)
Error Code
Description
406B 00A6
Wire tests detected no usable
memory
406B 00A7
Wire tests detected hardware
problem
406B 00B0
Wire tests detected bus controller
lock-unlock failure
406B 00B1
Wire tests diagnostics detected bus
controller failure
406B 00B7
Wire test detected insufficient
hardware resources to continue IPL
406B 0100
Wire tests detected memory riser
card fault
406B 0101
Wire tests detected memory DIMM
fault
406B 0102
Wire tests detected memory DIMM
fault
406B 0103
Wire tests detected memory DIMM
fault
406B 0104
Wire tests detected memory DIMM
fault
406B 010D
Wire tests detected memory DIMM
fault
406B 0111
Wire tests detected memory DIMM
fault
406B 0112
Wire tests detected memory DIMM
fault
Action/ Possible Failing FRU
1. Ensure that memory is properly
installed
2. If more than one DIMM is called
out, go to the service processor
Memory
Configuration/Deconfiguration
Menu to verify memory DIMMs
state. See "Memory
Configuration/Deconfiguration
Menu" on page 266 for more
information.
3. Go to "MAP 1540: Minimum
Configuration" on page 57
4. If the problem is not fixed, call
service support.
Go to "MAP 1540: Minimum
Configuration" on page 57.
System board, Location: P1
System board, Location: P1
This error code appears after the
initial testing by the service processor
firmware on the processors and
memory completed successfully, but
a problem occurred when the
firmware tried to communicate
outside the processor and memory
complex. Suspect a problem with the
backplane, location: P1.
Memory riser card Location: P1-M2
Memory DIMM Location: P1-M2.15
Memory DIMM Location: P1-M2.1
Memory DIMM Location: P1-M2.16
Memory DIMM Location: P1-M2.2
Memory DIMM Location: P1-M2.1 x4
Memory DIMM Location: P1-M2.13
Memory DIMM Location: P1-M2.3
Chapter 5. Error Code to FRU Index
163
Advertisement
Table of Contents
