Map 1020: Problem Determination - IBM F80 Service Manual

Symptom
You do not have a symptom.
You do not have a determined symptom.
All other problems.

MAP 1020: Problem Determination

Purpose of this MAP
Use this MAP to get an error code if you were not provided with one by the customer or
you are unable to load diagnostics. If you are able to load the diagnostics, go to "MAP
0020" in RS/6000 and Eserver pSeries Diagnostic Information for Multiple Bus
Systems .
The service processor may have recorded one or more symptoms in its error log. It is a
good idea to examine that error log before proceeding (see "System Information Menu"
on page 264).
Be prepared to record code numbers and use those numbers in the course of analyzing
a problem.
The service processor may have been set by the user to monitor server operations and
to attempt recoveries. You can disable these actions while you diagnose and service
the system. If the system was set up according to the recommendations of the RS/6000
Enterprise Server Model F80, Eserver pSeries 620 Models 6F0 and 6F1 User's Guide ,
all the settings of the service processor (except language) were saved by using the
SAVE/RESTORE HARDWARE MAINTENANCE POLICIES service aid. You can use
that same service aid to restore the settings at the end of your service action.
If the service processor settings were not saved by the user, if you disable them, you
should make notes of their current settings for restoration before you leave.
In addition to the parameters in the table below, you can disconnect the modem to
prevent incoming signals that could cause the Models F80, 6F0, or 6F1 to power on.
Following are the service processor settings. The service processor menus are
described in Chapter 7, "Using the Service Processor" on page 251.
48
Service Guide
Action
Go to MAP 0020: Problem Determination
Procedure in RS/6000 and Eserver pSeries
Diagnostic Information for Multiple Bus
Systems .
Go to MAP 0020: Problem Determination
Procedure in RS/6000 and Eserver pSeries
Diagnostic Information for Multiple Bus
Systems .
You Cannot Find the Symptom in this Table
Go to MAP 0020: Problem Determination
Procedure in RS/6000 and Eserver pSeries
Diagnostic Information for Multiple Bus
Systems .