IBM F80 Service Manual page 198

Table 7. Service Processor Error Codes (continued)
Error Code
406F 00A1
406F 00A2
406F 00A3
406F 00A4
406F 00A5
406F 00A6
406F 00A7
406F 00B0
406F 00B1
406F 00B7
406F 0100
180
Service Guide
Description
Error code generation/logging
detected system firmware fault
Error code generation/logging
detected service processor firmware
(PRD) fault
Error code generation/logging
detected memory plugging fault
Error code generation/logging
detected application caused fault
Error code generation/logging
detected invalid system configuration
Error code generation/logging
detected no usable memory
Error code generation/logging
detected hardware problem
Error code generation/logging
detected bus controller lock-unlock
failure
Error code generation/logging
detected bus controller failure
Error code generation/logging
detected insufficient hardware
resources to continue IPL
Error code generation/logging
detected memory riser card fault
Action/ Possible Failing FRU
1. Check for AIX updates
2. Check for system firmware
updates
Update system firmware
Go to "MAP 1540: Minimum
Configuration" on page 57.
Application software
Verify that system components are
supported and properly installed
1. Ensure that memory is properly
installed
2. If more than one DIMM is called
out, go to the service processor
Memory
Configuration/Deconfiguration
Menu to verify memory DIMMs
state. See "Memory
Configuration/Deconfiguration
Menu" on page 266 for more
information.
3. Go to "MAP 1540: Minimum
Configuration" on page 57
4. If the problem is not fixed, call
service support.
Go to "MAP 1540: Minimum
Configuration" on page 57.
System board, Location: P1
System board, Location: P1
This error code appears after the
initial testing by the service processor
firmware on the processors and
memory completed successfully, but
a problem occurred when the
firmware tried to communicate
outside the processor and memory
complex. Suspect a problem with the
backplane, location: P1.
Memory riser card Location: P1-M2