IBM F80 Service Manual page 194

Table 7. Service Processor Error Codes (continued)
Error Code
406E 00A6
406E 00A7
406E 00B0
406E 00B1
406E 00B7
406E 0100
406E 0101
406E 0102
406E 0103
406E 0104
406E 010D
406E 0111
406E 0112
176
Service Guide
Description
Scan control routines detected no
usable memory
Scan control routines detected
hardware problem
Scan control routines detected bus
controller lock-unlock failure
Scan control routines detected bus
controller failure
Scan control routines detected
insufficient hardware resources to
continue IPL
Scan control routines detected
memory riser card fault
Scan control routines detected
memory DIMM fault
Scan control routines detected
memory DIMM fault
Scan control routines detected
memory DIMM fault
Scan control routines detected
memory DIMM fault
Scan control routines detected
memory DIMM fault
Scan control routines detected
memory DIMM fault
Scan control routines detected
memory DIMM fault
Action/ Possible Failing FRU
1. Ensure that memory is properly
installed
2. If more than one DIMM is called
out, go to the service processor
Memory
Configuration/Deconfiguration
Menu to verify memory DIMMs
state. See "Memory
Configuration/Deconfiguration
Menu" on page 266 for more
information.
3. Go to "MAP 1540: Minimum
Configuration" on page 57
4. If the problem is not fixed, call
service support.
Go to "MAP 1540: Minimum
Configuration" on page 57.
System board, Location: P1
System board, Location: P1
This error code appears after the
initial testing by the service processor
firmware on the processors and
memory completed successfully, but
a problem occurred when the
firmware tried to communicate
outside the processor and memory
complex. Suspect a problem with the
backplane, location: P1.
Memory riser card Location: P1-M2
Memory DIMM Location: P1-M2.15
Memory DIMM Location: P1-M2.1
Memory DIMM Location: P1-M2.16
Memory DIMM Location: P1-M2.2
Memory DIMM Location: P1-M2.1 x4
Memory DIMM Location: P1-M2.13
Memory DIMM Location: P1-M2.3