Table of Contents
Advertisement
Replacement
1. Remove the VPD module from the old operator panel and insert it in the new
operator panel. Make sure you insert the module in the same position as it was in
the old panel.
1
2
2. Replace in reverse order.
Operator Panel Cable
Removal
Attention:
and time, and service processor call-in functions will be lost. These settings can be
reset after the cable is replaced.
1. Power off the system (see "Powering Off and Powering On the System" on page 9).
2. Disconnect the ac power cord from the system.
3. Remove the front cover to access the operator panel (see "Removing the Covers"
on page 311).
4. Pull the knobs on each side of the operator panel to unlock it.
5. Pull the operator panel outward from the system.
6. Loosen the thumbscrews that hold the cable restraint plate to the operator panel.
7. Slide the restraint plate to the back of the operator panel.
8. Disconnect the cable from the back of the operator panel.
9. Disconnect the cable from the system board
Replacement
1. Replace the operator panel cable by reversing the steps in the removal procedure.
2. Power on the system (see "Powering Off and Powering On the System" on page 9).
2
VPD Module
Cable Connector
If the operator panel cable is disconnected, settings for passwords, date
Chapter 9. Removal and Replacement Procedures
1
353
Advertisement
Table of Contents
