Table of Contents
Advertisement
6. Select Devices.
7. Select Install/Configure Devices Added After IPL and press Enter. Successful
configuration is indicated by the OK message displayed next to the Command field
at the top of the screen.
8. Press F10 to exit smitty.
9. Replace the front cover as described in "Replacing Covers" on page 314.
Configuring and Deconfiguring SCSI Hot-Swap Disk Drives
If you need to configure or deconfigure a drive, use the following procedures:
Configuring SCSI Hot-Swap Disk Drives
1. Log in as root user.
2. At the command line, type smitty.
3. Select System Storage Management (Physical and Logical Storage) and press
Enter.
4. Select Logical Volume Manager and press Enter.
5. Select Volume Groups and press Enter.
6. Select Set Characteristics of a Volume Group and press Enter.
7. Select Add a Physical Volume to a Volume Group.
8. Fill in the fields for the drive you are adding to the system. Press F4 for a list of
selections.
See the AIX System Management Guide: Operating System and Devices to finish
the drive configuration. This publication is located on the AIX Documentation CD.
Access the documentation information by loading the documentation CD onto the
hard disk or by mounting the CD in the CD-ROM drive.
9. Press F10 to exit smitty.
Deconfiguring SCSI Hot-Swap Disk Drives
1. Log in as root user.
2. At the command line, type smitty.
3. Select System Storage Manager (Physical and Logical Storage) and press
Enter.
4. Select Logical Volume Manager and press Enter.
5. Select Volume Groups and press Enter.
6. Select Set Characteristics of a Volume Group and press Enter.
7. Select Remove a Physical Volume from a Volume Group.
8. Press F4 to list the available volume groups. Then select the volume group name
and press Enter.
9. Press F4 to select a physical volume and follow the instructions on the screen to
select the physical volume. Then press Enter.
10. Return to the procedure that directed you here.
Chapter 9. Removal and Replacement Procedures
323
Advertisement
Table of Contents
