G60T Module
Figure 39
shows the G60T module.
Figure 39: G60T module
The G60T module has 60 autosensing 10/100/1000BASE-T ports that use standard RJ-45 connectors. If
you have one MSM installed, all ports on the G60T module are switched through that MSM. If you have
two MSMs installed, the top 30 ports on the G60T module are switched through the MSM in slot A, and
the bottom 30 ports are switched through the MSM in slot B during normal operation.
The default configuration of the G60T module is as follows. All ports:
Are added to the default VLAN as untagged
●
Inherit the properties of the default VLAN (for example, protocol type and VLANid)
●
Operate in autonegotiation mode
●
G60T LEDs
The G60T module has the following LEDs:
Module status
●
Port status
●
Port speed
●
For information about the LEDs and their activity on the G60T module, see
page
91.
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
About the BlackDiamond 10808 I/O Modules
Module status LEDs
RJ-45
connector
ports
EX_004
"I/O Module LEDs" on
83