Extreme Networks BlackDiamond 8800 Series Hardware Installation Manual page 169

Figure 101: Power cord brackets on two adjacent power supplies
2 Connect the AC power cord to the PSU as follows:
a Connect the AC power cord to the AC input on the front of the PSU (see
loosen the middle screw of the power cord bracket to allow installation of the power cord.
b After the power cord is connected, tighten the middle screw of the bracket to secure the power
cord in place (see Figure
Figure 102: Connecting the AC power cord
1
3 Connect the opposite end of the AC power cord to the wall outlet.
NOTE
Leave the ESD strap permanently connected to the switch, so that the strap is always available when you need to
handle ESD-sensitive components.
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
Torino AC PSU_09
102).
2
Extreme Networks 325 W AC Power Supply
Figure 102). If needed,
Torino AC PSU_08
169