Removing An Eps-150Dc - Extreme Networks BlackDiamond 8800 Series Hardware Installation Manual

Removing an EPS-150DC

WARNING!
Always be sure that the DC circuit is de-energized before disconnecting any cables and attempting to remove an
EPS-150DC unit.
WARNING!
Removing the DC wiring harness from your facilities DC source voltage requires the performance of a qualified,
licensed electrician.
To disconnect and remove an EPS-150DC unit:
1 Attach the ESD strap to your wrist and connect the metal end to the ground receptacle on the top-
right corner of the switch front panel.
2 De-energize the DC circuit.
3 Remove power from the switch by unplugging the DC connector from the DC power supply socket
on the rear of the EPS-150DC unit.
4 Disconnect the switch from the EPS-150DC unit by disconnecting the redundant power cord between
the two units.
5 Loosen the thumbscrews on the front of the EPS-T2 and slide the EPS-150DC out of the EPS-T2.
WARNING!
Removing the DC wiring harness from your facilities DC source voltage requires the performance of a qualified,
licensed electrician.
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
EPS-150DC External Power Module (with EPS-T2)
327