Extreme Networks BlackDiamond 8800 Series Hardware Installation Manual page 351

Figure 239: XFP module
Card edge
connector
WARNING!
XFP modules contain Class 1 lasers. Invisible laser radiation can occur when laser connections are unplugged. Do
not stare into the beam. This device is compliant with FCC 21 CFR 1040.10 and EN60825-1 A2:2001.
WARNING!
To prevent ESD damage to the XFP module, always use an appropriately grounded ESD-preventive wrist strap when
installing or removing the module. Handle the module by its sides only. Never touch the card-edge connectors at the
insertion end of the module.
To install an XFP module:
1 Remove the XFP module from its antistatic container and remove the dust covers from the module
optical connectors.
If your module has a protective pad covering the card-edge connector, remove it. Store the antistatic
container, dust covers, and card-edge connector protective pad in a clean location from which they
can be easily retrieved if you need to uninstall the module.
2 Remove any rubber dust covers from the port on the module into which you are installing the XFP
module.
3 On the Summit XGM2-2xf option card, move the handle to an upright position to access the XFP
ports (see Figure 240).
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
XFP Interfaces
XFP Module
SH_022
351