Repacking The Blackdiamond 12802 Chassis - Extreme Networks BlackDiamond 8800 Series Hardware Installation Manual

Repacking a BlackDiamond Chassis

Repacking the BlackDiamond 12802 Chassis

To repack the BlackDiamond 12802 chassis for return to Extreme Networks:
1 Prepare the shipping box. Remove saved packing materials except the lower foam cushion, which
should be in the bottom of the box.
2 Remove all modules and power supplies from the chassis. Follow correct Extreme Networks
procedures for removing components from the BlackDiamond chassis.
3 Remove the chassis from the equipment rack as follows:
a Loosen and remove the eight mounting screws holding the chassis to the rack.
b Guide the chassis out of the rack and set it on a secure, flat surface.
4 Remove the rack-mounting brackets.
5 Place the chassis into the shipping bag.
6 Carefully set the chassis onto the foam cushion in the bottom of the shipping carton (see
Figure 160: Packing the BlackDiamond 12802 chassis for shipping
7 Set the top foam cushion in place over the chassis (see
8 Close the top flaps and seal them securely with packing tape.
234
Figure 160).
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
Figure
BlackDiamond
12802 switch
BD_150
160.)