Removing A Blackdiamond 8800 Or 12800 Series Module - Extreme Networks BlackDiamond 8800 Series Hardware Installation Manual

Removing a BlackDiamond 8800 or 12800 Series
Module
CAUTION
There are two styles of ejector/injector handles on the BlackDiamond 12800 series modules. Pay careful attention to
the instructions in step 2.
This section describes how to remove modules from a BlackDiamond 8800 or 12800 series switch.
BlackDiamond modules are hot-swappable. You do not need to power the system off to remove a
module.
You will need the following tools and equipment to install a BlackDiamond 8800 MSM or I/O module:
ESD-preventive wrist strap
●
#2 Phillips screwdriver
●
To remove a BlackDiamond 8800 or 12800 series module:
1 Attach the ESD-preventive wrist strap to your wrist and connect the metal end to the ground
receptacle on the chassis.
On a BlackDiamond 12804 or 8800 series chassis, the ground receptacle is at the top left corner.
On a BlackDiamond 12802 chassis, the ground receptacle is at the top right corner.
2 Unlock the module in one of the following ways:
On a module without red lines on the screwheads, turn each captive screw counter-clockwise
●
(Figure 111). Verify that the yellow band around the captive screw head of each injector/ejector
handle is completely visible
On a module with red lines on the screwheads, turn each captive screw counter-clockwise one-
●
quarter turn (90 degrees)
horizontal position
CAUTION
Be sure to turn each captive screw only 90 degrees or one-quarter turn counter-clockwise. Loosening the captive
screws beyond 90 degrees will damage the injector/ejector handles on the module.
Figure 111: Unlocking a module
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
(Figure 111). This position ensures that the module is unlocked.
(Figure 111). Verify that the red line on each captive screw is in a
(Figure 112). This position ensures that the MSM or I/O module is unlocked.

Removing a BlackDiamond 8800 or 12800 Series Module

EX_125a
183