G60T Module; G60T Leds - Extreme Networks BlackDiamond 10808 Hardware Installation Manual

G60T Module

Figure 4 shows the G60T module.
Figure 4: G60T Module
Module status LEDs
RJ-45
connector
ports
The G60T module has 60 autosensing 10/100/1000BASE-T ports that use standard RJ-45 connectors. If
one MSM is installed in the switch, all ports on the G60T module are switched through that MSM. If
two MSMs are installed, the top 30 ports on the G60T module are switched through the MSM in slot A,
and the bottom 30 ports are switched through the MSM in slot B during normal operation.
The default configuration of the G60T module is as follows. All ports:
Are added to the default VLAN as untagged
●
Inherit the properties of the default VLAN (for example, protocol type and VLANid)
●
Operate in autonegotiation mode
●

G60T LEDs

The G60T module has the following LEDs:
Module status
●
Port status
●
Port speed
●
For information about the LEDs and their activity on the G60T module, see
page 29.
BlackDiamond 10808 Switch Hardware Installation Guide
EX_004
I/O Modules
"I/O Module LEDs" on
21