11
Installing BlackDiamond Series Modules
This chapter provides important safety information and correct installation procedures for the MSMs
and I/O modules in the BlackDiamond 8800 series switches, BlackDiamond 12800 series switches, and
BlackDiamond 10808 switches. All module types are hot-swappable.
The chapter includes the following sections:
●
●
●
●
●
●
●
●
●
●
NOTE
Read the information in this chapter thoroughly before you attempt to install or remove an 8800 series MSM or I/O
module.
CAUTION
Do not attempt to mix modules across Extreme Networks product lines. BlackDiamond 8800 series modules are for
use only in a BlackDiamond 8810 or 8806 switch. Blackdiamond 12800 series modules are for use only in a
BlackDiamond 12804 or 12802 switch. When a BlackDiamond switch is in use, ExtremeXOS software will not
recognize a module from a different product line.
Module Slot Assignments
The specific slot locations for I/O modules and MSMs in the chassis are as follows:
BlackDiamond 8810 switch:
●
Slots 1, 2, 3, 4, 7, 8, 9, and 10 must have I/O modules.
■
Slot 5/A must have an MSM.
■
Slot 6/B can have an MSM or I/O module.
■
BlackDiamond 8806 switch:
●
Slots 1, 2, 5, and 6 must have I/O modules.
■
Slot 3/A must have an MSM.
■
Slot 4/B can have an MSM or I/O module.
■
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
173