Installing An Extreme Networks 600/900 W Ac Psu - Extreme Networks BlackDiamond 8800 Series Hardware Installation Manual

Extreme Networks Power Supply Units for BlackDiamond Switches

Installing an Extreme Networks 600/900 W AC PSU

CAUTION
Make sure that the Extreme Networks 600/900 W AC PSU circuit is not overloaded. Use proper over-current
protection, such as a circuit-breaker, to prevent over-current conditions.
To install an Extreme Networks 600/900 W AC PSU:
1 Attach an ESD-preventive wrist strap to your wrist and connect the metal end to the ground
receptacle, which is located on the top-left corner of the switch front panel.
2 Verify that the Extreme Networks 600/900 W AC PSU is right side up and the locking handle is
open (see Figure
Figure 90: Extreme Networks 600/900 W AC PSU with locking handle open
3 Carefully slide the Extreme Networks 600/900 W AC PSU all the way into the power supply bay
(see Figure
CAUTION
Do not slam the Extreme Networks 600/900 W AC PSU into the system switch backplane. Use the locking handle to
secure the Extreme Networks 600/900 W AC PSU into the system switch.
Figure 91: Inserting a 600/900 W AC PSU into the power supply bay
154
90).
91).
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
EX_015
EX 174