Channel Function Setup; Channel Group; Scan Memory; Scan Type - Standard Horizon GX2200 Owner's Manual

11 CHANNEL FUNCTION SETUP

11.1 CHANNEL GROUP

This section selects a channel group from USA, Canada, and International.
Refer to section "8.6 USA, CANADA, AND INTERNATIONAL MODE" for
details.

11.2 SCAN MEMORY

To be able to scan channels the radio must be programmed. This section
allows channels to be stored in scan memory.
Refer to section "8.9.2 Programming Scan Memory" for details.

11.3 SCAN TYPE

This selection is used to select the scan mode between "Memory Scan" and
"Priority Scan". The default setting is "Priority Scan".
Refer to section "8.9.1 Selecting the Scan Type" for details.

11.4 SCAN RESUME

This selection is used to select the time the GX2200 waits after a transmis-
sion ends before the radio start to scan channels again. The default setting is
2 seconds.
1. Press and hold the
appears.
2. Rotate the CH knob to select " CH FUNCTION
SETUP ".
3. Press the
RESUME " with the CH knob.
4. Press the
5. Rotate the CH knob to select the desired resume
time, default is 2 seconds. The resume time can
be set to " 1SEC " through " 5SEC " or " Off ". In the " Off "
selection, the scanner will resume after the other
station stops transmitting (carrier drops).
6. Press the
setting.
7. Press the
to radio operation.
GX2200
key until " Setup Menu "
CALL
MENU
soft key, then select " S C A N
soft key.
soft key to store the new
soft key several times to return
-Scan Resume-
5 sec
4 sec
3 sec
2 SEC
1 sec
Off
ENT QUIT
Page 99