Gps Setup; Unit Power; Coordinate System - Standard Horizon GX2200 Owner's Manual

15 GPS SETUP

The "GPS Setup" mode allows the parameters for the GX2200 internal GPS
unit to be custom-configured for your operating requirements.

15.1 UNIT POWER

This selection allows the internal GPS unit to be turned on or off. When you
use the optional Standard Horizon GPS Antenna (Q7000619A) or the radio is
connected to an external chart plotter, set this selection to "OFF". The default
setting is "ON".
1. Press and hold the
Menu " appears.
2. Rotate the CH knob to select " GPS SETUP "
menu.
3. Press the
POWER " with the CH knob.
4. Press the
5. Rotate the CH knob to select " ON ".
6. Press the
setting.
7. Press the
radio operation.

15.2 COORDINATE SYSTEM

This menu item selects the coordinate system to be shown on the GX2200
display. The default setting is "ddd mm.mmm".
1. Press and hold the
Menu " appears.
2. Rotate the CH knob to select " GPS SETUP "
menu.
3. Press the
" COORDINATE SYSTEM " with the CH knob.
4. Press the
CH knob to select the desired coordinate
system. The coordinate system can be
selected from " ddd mm ss ", " ddd mm.mm ",
and " ddd mm.mmm ".
5. Press the
6. Press the
GX2200
key until " Setup
CALL
MENU
soft key, then select " UNIT
soft key.
soft key to save the new
soft key twice to return to
key until " Setup
CALL
MENU
soft key, then select
soft key, then rotate the
soft key to save the new setting.
soft key twice to return to radio operation.
Page 121