Position Reply; Auto Pos Interval; Dsc Beep - Standard Horizon GX2200 Owner's Manual

12.6 POSITION REPLY

The GX2200 can be set up to automatically (default setting) or manually
send your position when requested by another vessel. This selection is
important if you are concerned about someone polling the position of your
vessel that you may not want to. In the manual mode you will see the MMSI
or persons name shown on the display allowing you to choose to send your
position to the requesting vessel.
Refer to section "9.7.1 Setting up a Position Request Reply" for details.

12.7 AUTO POS INTERVAL

The GX2200 has the capability to automatically track four stations
programmed into the individual directory.
Selecting the auto position polling time interval between position request
transmissions to be setup.
Refer to section "9.10.1 Setting up the Polling Time Interval" for details.

12.8 DSC BEEP

This feature allows the alarm beeps to be turned on (default setting) or off
when a DSC call is received. The DSC calls that can be customized are:
individual, group, all ships, position request, and position report.
1. Press and hold the
appears.
2. Rotate the CH knob to select " DSC SETUP " menu.
3. Press the
with the CH knob.
4. Press the
knob to the desired DSC call type and press the
soft key.
5. Rotate the CH knob to turn " On " or " Off " the DSC
beep and press the
6. Press the
radio operation.
GX2200
key until " Setup Menu "
CALL
MENU
soft key, then select " DSC BEEP "
soft key, then rotate the CH
soft key.
soft key three times to return to
-DSC Beep-
Select Call
Individual
Beep
On
ENT QUIT
Page 105