14.7 STOPPING NAVIGATION TO A WAYPOINT
To stop navigating to a waypoint, the radio must be switched to the normal
mode with the following procedure.
1. Press and hold the
appears.
2. Rotate the CH knob to select " GENERAL SETUP "
menu.
3. Press the
with the CH knob.
4. Press the
5. Rotate the CH knob to select " NORMAL ".
6. Press the
ation.
14.8 SELECTING THE WAYPOINT RANGE
This menu item allows setting of the range on the display. The default setting
is "Automatic".
1. Press and hold the
Menu " appears.
2. Rotate the CH knob to select " WAYPOINT
SETUP ".
3. Press the
" DISPLAY RANGE " with the CH knob.
4. Press the
5. Rotate the CH knob key to select desired
range. Available selections are "Automatic",
"0.5NM", "1NM", "2NM", "5NM", "10NM",
"15NM", "20NM", and "30NM".
6. Press the
7. Press the
Page 120
key until " Setup Menu "
CALL
MENU
soft key, then select " DISPLAY "
soft key.
soft key to return to radio oper-
key until " Setup
CALL
MENU
soft key, then select
soft key.
soft key to store the selected setting.
soft key twice to return to radio operation.
GX2200