Setting Up A Position Request Ringer - Standard Horizon GX2200 Owner's Manual

Manual reply:
1. When a position request call is received from
another vessel, the display will be as shown in
the illustration at the right.
2. A ringing alarm sounds 4 times. To send your
vessels position to the requesting vessel, press
the soft key. Or to exit from position
REPLY
request display, press the

9.7.4 Setting up a Position Request Ringer

The GX2200 has the capability to turn off the position request ringer.
1. Press and hold the
Menu " appears.
2. Rotate the CH knob to select " DSC SETUP "
menu.
3. Press the
BEEP " with the CH knob.
4. Press the
Request " with the CH knob.
5. Press the
with the CH knob.
6. Press the
selected setting.
7. Press the
To re-enable the ringer tone, repeat the above procedure, rotating the CH
knob to select " On " in step 5 above.
Page 74
key until " Setup
CALL
MENU
soft key, then select " DSC
soft key, then select " POS
soft key, then select " Off "
soft key to store the
soft key several times to return to radio operation.
soft key.
Received POS Request
Name:Horizon
ID:123456789
Category:Routine
Since: 01:03
REPLY QUIT
Received POS Request
Name:Horizon
ID:123456789
Category:Routine
Since: 01:03
Transmitted
QUIT
GX2200