Programming The Mmsi - Standard Horizon GX2200 Owner's Manual

THIS NUMBER MUST BE PROGRAMMED INTO THE RADIO TO OPER-
ATE DSC FUNCTIONS.
How can I obtain an MMSI assignment?
In the USA, visit the following websites to register:
http://www.boatus.com/mmsi/
http://seatow.com/boating_safety/mmsi.asp
http://www.usps.org/php/mmsi/rules.php
In Canada, visit
http://www.ic.gc.ca/epic/site/smt-gst.nsf/en/sf01032e.html

9.2.2 Programming the MMSI

The MMSI can be inputted only once. Therefore please be care-
ful not to input the incorrect MMSI number. If you need to change
the MMSI number after it has been entered, the radio will have to be
returned to Factory Service. Refer to the section "17.2 FACTORY
SERVICE."
1. Press and hold the
Menu " appears.
2. Rotate the CH knob to select " MMSI SETUP ".
3. Press the
the soft key.)
4. Rotate the CH knob to select the first
number of your MMSI, then press the
soft key to step to the next number.
5. Repeat step 4 to set your MMSI number
(nine digits).
6. If a mistake was made entering in the MMSI
number, press the
wrong number is selected, then rotate the
CH knob to correct the entry and press the
soft key.
7. When finished programming the MMSI
number, press and hold the
The radio will ask you to input the MMSI
number again. Use steps 4 through 6
above.
Page 50
WARNING
key until " Setup
CALL
MENU
soft key. (To cancel, press
soft key until the
-User MMSI-
Input User MMSI
---------
ENT
-User MMSI-
Input User MMSI
*********
Input Again
---------
ENT
soft key.
QUIT
BACK
-User MMSI-
Input User MMSI
123456789
QUIT
ENT BACK
-User MMSI-
Input User MMSI BACK QUIT
*********
Input Again
123456789
ENT BACK QUIT
GX2200