Standard Horizon GX2200 Owner's Manual page 68

Group Call by Manually Entering an MMSI
This feature allows you to contact a group of vessels by entering in their
group MMSI manually.
1. Press the
appear.
2. Rotate the CH knob to select " GROUP ". (To
cancel, press the
3. Press the
will beep, and the last group calls will
appear.
4. Press the
MANUAL
" " with the CH knob.
5. Press the
6. Rotate the CH knob to select the first
number of the MMSI (nine digits: first digit
permanently set to "0") which you want to
contact, then press the
step to the next number.
7. Repeat step 6 to set the MMSI number.
If a mistake was made entering in the MMSI
number, repeat pressing the
key until the wrong number is selected,
then rotate the CH knob to correct the entry.
8. When finished entering the MMSI number,
press and hold the
9. Rotate the CH knob to select the operating
channel you want to communicate on, then
press the
10. Press the
11. After the group call is transmitted, all the radios in the group will switch
to the designated channel.
12. Listen to the channel to make sure it is not busy, then press the PTT
switch and talk into the microphone to the group of vessels.
Page 68
key. The " DSC Menu " will
CALL
MENU
soft key.)
soft key. The transceiver
soft key, then select
soft key.
soft key.
soft key.
soft key to transmit the group call signal.
Input Group
ID:034567891
SELECT
soft key to
Category:Routine
soft
YES
Category:Routine
-Group Call-
Input Group
ID:0--------
-Group Call-
SELECT BACK
BACK QUIT
-Group Call-
Name:
ID:034567891
CH: 08
Transmit?
QUIT
-Group Call-
Name:
ID:034567891
CH: 08
Since: 00:25
QUIT
GX2200
QUIT