Single Slot Charge Only Vehicle Mount - Motorola MT2070 User Manual

15 - 8 MT2070/MT2090 User Guide

Single Slot Charge Only Vehicle Mount

Troubleshooting the Single Slot Charge Vehicle Mount Cradle
Table 15-3
Symptom
Device battery charging LED does
not light (when using the power
converter).
Device's battery is not recharging.
Device falls out of the cradle
during vibrations.
Device does not boot when placed
in the cradle.
Possible Cause
Cradle is not receiving power.
Power converter fuse is blown.
Power converter is faulty.
Device was removed from the
cradle too soon.
Device battery is faulty.
Device was not placed correctly
in the cradle.
Cradle latches are adjusted
incorrectly.
Incorrect adapter cup.
The device's battery is
discharged.
Action
Ensure cables to cradle and power converter are
securely connected.
Replace power converter fuse.
Replace power converter.
Replace the device in the cradle. If the device's
battery is fully depleted, it can take four hours to
fully recharge the battery.
Replace the battery.
Remove the device from the cradle, and re-insert. If
the battery still does not charge, contact your
system administrator.
Remove cradle from the shock absorbing plate by
unscrewing 3 screws; check that the position of the
wall mount conversion dial is set to the wall-mount
position; reattach the cradle to the shock absorbing
plate.
Ensure the forklift cup is mounted.
Normal behavior if the battery is severely
discharged. The battery must charge at a reduced
charge rate until the battery acquires sufficient
charge to boot the device. This can take up to two
hours, depending on the level of battery discharge.
This can be avoided by powering the cradle with
the optional external power supply.