Motorola MT2000 Series Quick Start Manual

MT 2000 Series
Quick Start Guide
http://www.motorola.com/mt2070 Refer to User Guide for detailed information
http://www.motorola.com/mt2090
BATTERY INSERTION
1
CONNECTIONS
Cradle Cable Connections
Host
Power
Scanner Cable Connection
(USB & RS-232 only)
NOTE: Cables may vary depending on configuration. When using an external power supply, insert the
power cable into the cradle first, then insert the host cable. Connect the power cable to an AC outlet last.
Refer to the MT2000 Series User Guide Troubleshooting section for further information.
Scanner not working
No power to scanner NOTE: Under certain circumstances, a fully discharged battery can take up to 30
minutes to charge before the scanner is operational. Refer to the User Guide for
detailed information.
Check battery
Scanner decoding bar code, but data not transmitting to host
Scanner not paired to host-connected cradle Cradle not programmed for correct host interface
Pair the scanner to the cradle (using the
PAIR bar code on the cradle)
NOTE: If data is still not transmitting to host, it may be necessary to recycle power on the cradle.
RS-232 Host Types
STANDARD RS-232
ICL RS-232
NIXDORF RS-232 MODE B
FUJITSU RS-232
NIXDORF RS-232 MODE A
OPOS/JPOS
USB Host Types
HID KEYBOARD EMULATION
IBM HAND-HELD USB
ACTIVESYNC HOST
1
2
3
4
5
6
7
2
Interface cable is loose
Check scanner host parameters or Check for loose cable
connections
edit options
MT2000 SERIES PROGRAMMING BAR CODES
Host Types
Keyboard Wedge Host Types
IBM PC/AT and IBM PC COMPATIBLE
Radio Communications Host Types
CRADLE HOST
BLUETOOTH KEYBOARD EMULATION (HID SLAVE)
IBM 46XX Host Types
PORT 5B
8
9
10
11
13
14
1 Left soft & ALT key
2 Tab & * key
3 Keypad
4 Orange key
5 Blue key
6 Battery
7 Tether Plate
8 LED Indicator
9 Scan Window
10 4-way Navigation key
1 1 Right soft & CTRL key
12 Cold boot trigger
13 LED Indicator (MT2090 Only)
14 Enter key
15 Scan Trigger
RS-232
OR
USB
OR
TROUBLESHOOTING
Scanner not decoding bar code
Scanner not programmed
for bar code type
Ensure scanner is programmed
to read type of bar code being
scanned
Scanned data incorrectly displayed on host
Paired cradle host communication parameters do not match the host's parameters
Check cradle host parameters or edit options
SERIAL PORT PROFILE (SLAVE)
SERIAL PORT PROFILE (MASTER)
PORT 9B
Insert Scanner in Cradle
Desk Cradle
12
15
Wall Cradle
BATTERY REMOVAL
1
2
HOST INTERFACES
Keyboard Wedge
IBM 46XX
Bar code unreadable
Ensure bar code is not defaced;
try scanning test bar code of same
bar code type

Host Mode

CABLE PRIORITY
WIRELESS ONLY
Miscellaneous
Restore Defaults
Note: Paired scanners disconnect from the cradle
when Restore Defaults is scanned.
RESTORE DEFAULTS
Set Factory Defaults
Note: The Set Factory Defaults parameter only
changes the scanner's programmable parameters to
the factory defaults.
SET FACTORY DEFAULTS
Scan to Add an Enter Key
(Carriage Return/Line Feed)
SCAN OPTIONS
ENTER
Unpairing/Disconnection
UNPAIR/DISCONNECT
Forklift Cradle
3
Scanning application is not running
From the Home screen display on the
scanner, select Scan Item to run the
scanning application
CABLE ONLY
<DATA><SUFFIX>