User-Programmable Supplementals; Upc/Ean/Jan Supplemental Redundancy - Motorola MT2070 User Manual

User-Programmable Supplementals

Supplemental 1: Parameter # F1h 43h
Supplemental 2: Parameter # F1h 44h
If you selected a Supplemental User-Programmable option from
12-10, select User-Programmable Supplemental 1 to set the 3-digit prefix. Then select the 3 digits using the
numeric bar codes beginning on
prefix. Then select the 3 digits using the numeric bar codes beginning on
User-Programmable Supplemental 1
NOTE
currently not supported.
User-Programmable Supplemental 1

UPC/EAN/JAN Supplemental Redundancy

Parameter # 50h
If you selected Autodiscriminate UPC/EAN/JAN Supplementals, this option adjusts the number of times to
decode a symbol without supplementals before transmission. The range is from two to thirty times. Five or above is
recommended when decoding a mix of UPC/EAN/JAN symbols with and without supplementals. The default is 10.
Scan the bar code below to set a decode redundancy value. Next, scan two numeric bar codes in
Numeric Bar Codes. Enter a leading zero for single digit numbers. To correct an error or change a selection, scan
Cancel on page D-3.
UPC/EAN/JAN Supplemental Redundancy
page D-1. Select User-Programmable Supplemental 2 to set a second 3-digit
User-Programmable Supplemental 2 are
and
Decode UPC/EAN/JAN Supplementals on page
page D-1.
User-Programmable Supplemental 2
Symbologies 12 - 13
Appendix D,