Chapter 4 Radio Communications; Introduction; Scanning Sequence Examples; Errors While Scanning - Motorola MT2070 User Manual

Chapter 4 Radio Communications

Introduction

This chapter provides information about the modes of operation and features available for wireless communication
between MT20X0s, cradles and hosts. The chapter also includes the parameters necessary to configure the
device.
The device ships with the settings shown in the
Parameters for all host device and miscellaneous device defaults). If the default values suit requirements,
programming is not necessary.
To set feature values, scan a single bar code or a short bar code sequence. The settings are stored in non-volatile
memory and are preserved even when the device is powered down.
If not using a USB cable with the cradle, select a host type (see each host chapter for specific host information)
after the power-up beeps sound. This is only necessary upon the first power-up when connected to a new host.
To return all features to default values, scan a bar code in
programming bar code menus, default values are indicated with asterisks (

Scanning Sequence Examples

In most cases, scan one bar code to set a specific parameter value.

Errors While Scanning

Unless otherwise specified, to correct an error during a scanning sequence, just re-scan the correct parameter.
*
Disable Pair on Contacts
*
Indicates Default
Table 4-1 on page 4-2 (also see
Set Default Parameter on page
Appendix A, Standard Default
5-4. Throughout the
*
).
Feature/Option