Chapter 6 Imaging Preferences; Introduction - Motorola MT2070 User Manual

Chapter 6 Imaging Preferences

Introduction

You can program the device to perform various functions, or activate different features. This chapter describes
imaging preference features and provides programming bar codes for selecting these features.
The device ships with the settings in
Standard Default Parameters
requirements, programming is not necessary.
To set feature values, scan a single bar code or a short bar code sequence. The settings are stored in non-volatile
memory and are preserved even when you power down the device.
NOTE Most computer monitors allow scanning the bar codes directly on the screen. When scanning from the
screen, be sure to set the document magnification to a level where you can see the bar code clearly, and
bars and/or spaces are not merging.
If not using a USB cable, select a host type after the power-up beeps sound. See
Chapter 8, RS-232 Interface
connecting to a new host.
To return all features to default values, scan the
bar code menus, asterisks (
*
Imaging Preferences Parameter Defaults on page 6-2
for all host device and miscellaneous defaults). If the default values suit
for specific host information. This is only necessary upon the first power-up when
*
) indicate default values.
*
Enable Decode Aiming Pattern
Indicates Default
Set Default Parameter on page
(02h)
(also see Appendix A,
Chapter 9, USB Interface
5-4. Throughout the programming
Feature/Option
Option Hex Value
and